Banggood

Excellent qualité. Permet un remplacement facile et rapide.

Good quality, good price.

They look fine. I have not tested them, as they are for emergency spares.

zeer goed

this one saved the next prints. Good quality heater for 3d printers including a long wire. It was actually very easy and handy to build your own hot end with heaters and thermistors and it is easy to get a good quality hot ends with these.

I think I got ripped of with the cartridge supplied with my e3d j6 this has fixed a heating problem I was having and always handy to have a few spares as well.

These generic 12 volt heater elements are a must to have for occasional replacements for any 3D printer . I always have extras around for printing higher temp ABS filament .

The leads are quite long, sufficient for the Anet A8. The leads before the cartridge are nicely isolated, and the cartridge itself is looking good. No complaints whatsoever.

Качество вроед неплохое, греют. Полноценно пока не испытывал.

1 out of 10 Cartridge was defective. But I am still happy I got the 12V this time and not 24V again!