Customer Reviews

5 out of 5
Write a Review
  • All Reviews (7)
  • Image (0)
  • Video (0)
  • All Star
    • All Star(7)
    • 5 Star(7)
    • 4 Star(0)
    • 3 Star(0)
    • 2 Star(0)
    • 1 Star(0)
Sort by:
Top Review
  • Top Review
  • Most Helpful
  • Most Recent
Reviews only from your country (Indonesia)
  • 09/05/2019

    This is a great interface for the multiplexer chip, and very easy to use. Basically, it is a 1-to-8 or a 8-to-1. It works both ways! Essentially, you apply true/false to the S0, S1, and S2 inputs in the combination of a binary number to indicate which of the Y pins you want connected to the Z pin. Then it acts as though it has physically connected the two pins, and only those two pins, together. Power goes both ways. Simplest application: Connect each Y pin to an LED, then an appropriate resistor (440Ohm) and then to ground. Connect the Z pin to Vcc (5V). Connect the VCC to 5V and GND to ground. Connect E to ground to enable the board (high will disable it.) Then connect each of the S pins to either VCC or GND in different combinations. For each combination, a different LED will be lit. This component is best used when you have 8 outputs that can be activated one at a time, but only have 4 or 5 pins for your output. If you combine two of these boards, you can use the E pin as a fourth addressing bit, turning 5 pin outputs into 16.

  • 13/08/2019


  • 10/06/2019


  • 25/04/2019


  • 22/01/2019

    works as expected with my arduino project

  • 26/03/2018

    exactly what i needed

  • 09/11/2016

    Articolo ok


    Total 0 pages

    Go to page

    recommendation for you
    • Rp91,916.86
    • Rp101,455.41
    • Rp108,681.57
    • Rp272,715.60
    • Rp324,021.40
    • Rp87,870.21
    • Rp214,472.68
    • Rp366,077.70
    • Rp249,447.34
    • Rp349,746.56
    • Rp142,355.52
    • Rp223,577.65
    • Rp61,856.00
    • Rp137,008.15
    • Rp158,831.18
    • Rp162,877.84
    • Rp260,575.64
    • Rp202,188.19