Compatibility
To confirm that this part fits your vehicle, please enter your vehicle's details below.
-
Year:
-
Make:
-
Model:
-
Submodel:
-
Trim:
-
Engine:
- Clear All
This part is compatible with 0 vehicle(s).
Show all compatible vehicles
This part is compatible with 1 vehicle(s) matching
This part is not compatible with
- Year
- Make
- Model
- Submodel
- Trim
- Engine
Introduction to MKS- SGen L:
MKS-SGen L is a very powerful 3D printer ARM motherboard, using a 32-bit Cortex-M3 LPC1768 processor, clocked at up to 100MHZ, and the processing power is very stable. It is a versatile and cost-effective motherboard.
Advantage:
1. Using 32-bit Cortex-M3 LPC 1768 main chip, 100MHZ frequency, strong computing power, performance greatly improved.
2. Both in-line drive socket and external drive port. In-line driver compatible with various modes of various drivers (uart, spi, etc.)
3. Compatible with a variety of drivers and special modes (the UART mode of the TMC2208, the SPI mode of the TMC2130, etc.) has a dedicated port reservation, and the wiring settings are more concise and convenient.
4. Support a variety of open-source firmware, powerful and powerful. Continuing the smoothieware firmware used in the original s series motherboards, SGen-L can also support the firmware of the marlin2.0 version.
5. High-quality circuit boards are used, and the corresponding pins of each interface are marked with silkscreen, which makes it easier to identify and modify. 6. Use dedicated power chip to support 12V-24V power input.
7. Support the MKS LCD12864, MKS MINI12864 and other control boards developed by the maker base for display control.
8. It can be used with all touch screens of MKSTFT.
9. Compatible with a variety of LCD screens and MKS series touch screen
Parameter:
Motherboard model: MKS-SGEN L
Mounting hole size: 102mmX 76mm
Appearance size: 110mm* 84mm
Microprocessor: 32-bit Cortex M3 (LPC 1768/100Mhz)
Input voltage: 12V~24V
Motor Driver: TMC2130/2208/2100/4988/8825 Temperature Sensor Interface: NTC100K/PT100
Display: Support MKSTFT series screen and LCD screen
Support for print file format: G-code
Recommended software Cura/Simplify3d/Pronterface/Repetier-Host
Firmware update: TF card update
Support machine structure: XYZ/Kossel/Ultimaker/Corey, ect 3D Printer
About TB67S109
S109a driver module is based on the design and manufacture of tb67s109 stepping motor driver chip, which adopts four layers of thick copper gold deposition PCB and automatic chip placement processing. The module adopts indexer (dir / step) control interface, which can provide 4A driving current at most, drive 57 step motor, and is compatible with Polo pin definition. It can be directly used as a substitute of a4988 module.
Features:
Adopt four layer thick copper sinking gold PCB
Allow full step, 1 / 16, 1 / 32 step operation
Maximum input voltage: 50V; maximum output current: 4a (good heat dissipation condition required)
Equipped with large heat sink, the module can obtain better heat dissipation effect
High efficiency motor current control (advanced dynamic mixed attenuation ADMD, ADMD technology can track input current more closely than traditional mixed attenuation mode, so as to realize high efficiency motor control under high speed condition). See tb67s109 chip data sheet for details
On chip error detection circuit (TSD, ISD, POR)
Package Included:
1 x MKS SGEN L Board
5 x TB67S109
5 x Heat Sink
1 x USB Cable
