Banggood

The plate is 2mm thick, not 13.6mm as described. There is a hole in the plate for the thermistor and mine came without a plug but with connectors soldered directly to it. No LED installed either.

good product.

Heated bed is ok... but packaging should be better. It was protected only by bubbled plastic foil, no box. As result one corner was a little dented. After fixing this looks ok. Delivered by PostNL, so good service. If your post is not so nice for packets... be aware...

it is not pin tipe.it is soldered tipe heatbed and there's no led indication on heated bed.

arrived very well, great quality and awesome upgrade for my A5, all the communication with the vendor is great, but need better pachagin

it is not socket tipe there is no led indicator and it is soldered tipe

unfortunately it is not the Heatbed pictured. resistance is ~2Ohm so "only" 290Watt at 24v/ 72W at 12v could take for ever to Heat up.

received undamaged bought for diy printer looks like it will serve the intended purpose

Angle bent by transportation, no connector, but cables directly soldered on the pads, only 2mm thickness

Plate is 2mm thick. Resistance is 2 Ohms. Will reach 60C on 12V (ca 70W). With 150W power it can reach over 100C, although it takes some time. Screw holes are 300mm apart. Came with high quality silicone cables, very flexible. No connector as shown in the picture. Arrived completely flat, which is a miracle since it pretty much was sent in a plastic bag. One corner is just slightly bent though.