The airplane arrived neatly packaged (in the outer box) from the CZ warehouse. Unfortunately, it had a few small dents on the wings. The battery board (according to the photos from a review by another user) was completely missing and had to be made by myself. There were also no stickers available. It is flown with a 2200 mAh 4s LiPo, 50 Amp Hobbywing Skywalker controller, and a 64 mm EDF for 4s from Freewing. No landing gear has been installed. The model can be flown well if the battery is placed about 1 cm behind the narrowing in the fuselage and the ailerons are raised about 2-3 mm. It should always be flown with sufficient speed; a crash was narrowly avoided during a (provoked) stall. Building the airplane requires basic model making knowledge (not for beginners).

Das Flugzeug ist ordentlich verpackt (im Überkarton) vom CZ-Lagerhaus angekommen. Leider hatte es auf den Tragflächen ein paar kleine Dellen. Das Akkubrett (lt. den Fotos von einer Bewertung von einem anderen User) hat komplett gefehlt und musste selbst angefertigt werden. Aufkleber waren auch keine vorhanden. Geflogen wird mit einem 2200 MAh 4s Lipo, 50 Amp Hobbywing Skywalker Regler und einem 64 mm EDF für 4s von Freewing. Es ist kein Fahrwerk verbaut worden. Das Modell kann gut geflogen werden, wenn der Akku ca. 1 cm hinter der Verjüngung im Rumpf liegt und die Querruder ca. 2-3 mm nach oben gestellt werden. Es sollte immer mit ausreichender Geschwindigkeit geflogen werden, bei einem (provozierten) Strömungsabriss konnte ein Absturz nur ganz knapp vermieden werden. Der Bau des Flugzeuges setzt modellbautechnisches Grundwissen voraus (= nichts für Anfänger).

The airplane arrived neatly packaged (in the outer box) from the CZ warehouse. Unfortunately, it had a few small dents on the wings. The battery board (according to the photos from a review by another user) was completely missing and had to be made by myself. There were also no stickers available. It is flown with a 2200 mAh 4s LiPo, 50 Amp Hobbywing Skywalker controller, and a 64 mm EDF for 4s from Freewing. No landing gear has been installed. The model can be flown well if the battery is placed about 1 cm behind the narrowing in the fuselage and the ailerons are raised about 2-3 mm. It should always be flown with sufficient speed; a crash was narrowly avoided during a (provoked) stall. Building the airplane requires basic model making knowledge (not for beginners).

everything needed in the kit . I put 64mm edf and 4s 2200 battery . elevator trim up in regular position. using a opterra 1.2m rx from HH . plane flys excellent no complaints. throw to fly

everything needed in the kit . I put 64mm edf and 4s 2200 battery . elevator trim up in regular position. using a opterra 1.2m rx from HH . plane flys excellent no complaints. throw to fly

everything needed in the kit . I put 64mm edf and 4s 2200 battery . elevator trim up in regular position. using a opterra 1.2m rx from HH . plane flys excellent no complaints. throw to fly