Best Deals for Cleaning Brush - Banggood SEA Online Shopping

:

Shipping to:

Language:

Currency:

Hello Sign in Join
Sign in Join us
New customer? Start here.
0

inspironator

My Contents: All Messages; Reviews; Comments; Answers; Questions

All Messages

inspironator 12/03/2018

This is exactly what I needed and expected. I'm happy.

Insulation Piercing Needle Non-destructive Multimeter Test Probes Red/Black

US$3.99 US$7.99

0

Comments (0)

inspironator 12/03/2018

Works almost like magic. It does take some scrubbing effort, but remove only 3 mm of tape off one end (unlike the banggood photo shows) so the glass fibers are held tightly grouped against the surface. Since these are glass fibers, any time you use it on a surface where food is likely to contact, be sure to thoroughly wash the surface so you don't injest the bits of glass fiber -- save your health! I'm going to see if it helps the old brushed aluminum cover of my motor cycle muffler to see if it makes it like new again. I think it will!

Honana 2 Pcs Magic Stainless Steel Cleaning Brush Stick Metal Rust Remover Kitchen Cleaning Tools

US$8.99 US$10.99

6

Comments (0)

inspironator 12/03/2018

It looks like what I expected, but since I didn't know the input and output tube sizes before I ordered this, I'll have to fabricate adapters now. I just hope my smaller hose vacuum cleaner can produce the suction required by this higher flow capacity cyclone to as-effectively remove dirt. Manufacturing quality is good, and the unit is sealed as expected. Good value.

High Efficiency Cyclone Powder Dust Collector Filter Top Quality For Vacuums IA1

US$18.42 US$22.10

0

Comments (0)

inspironator 12/03/2018

Everything expected and it also included a European Plug in addition to the US Plug I needed. Assembly instructions were fine, and not difficult. Most other information was included in the SD card. The SD card was scanned by my computer, and it found malware in the Chinese subdirectory. This is bad! Other than that, the printer works okay. The box included everything needed to assemble and get started including a cat gcode file. The 0.5Kg spool of PLA is a very nice white with translusence, but the spool didn't identify the brand of PLA, best print temperature...no label at all, which I would like to be able to order from Banggood. I didn't find any slicer settings used to create the previously mentioned Cat gcode print file included with the printer. It would have been nice to start my slicer with the same settings. The spool of blue filler that gets cut and inserted into the slots of the 20/20 and 20/40 framing of the CR-10 had a strong offgassing odor. Is that vinyl acetate gassing off? It was so strong, I had to remove the printer from the living area to the garage before I became too sick. If I had to do it over again, I would suggest Creality provide the appropriate gcode files to create the blue/yellow inserts into the tracks and provide 1 Kg of PLA instead of a half Kg. PLA is a safer plastic for use in the home. Manufacturing quality is good. I only found 2 screws in the entire machine that were not as tight as the rest. The worm gear rod was also lubricated to my surprise.

Creality 3D® CR-10 DIY 3D Printer Kit 300*300*400mm Printing Size 1.75mm 0.4mm Nozzle

US$389.99 US$444.39

0

Comments (0)