All Messages

Q: 1. what is the clamping range? 2. can I attach regular drill bits?

Asked by MannySaunders on 2020-10-21 11:48:48

Aurum The range is minimal as it's meant to lock on the rectangular end part of the drill taps. You can put drills in it but why would you? It's not a chuck. Use a proper tool for that.

2020-10-21 02:40:33 Helpful (0)
Submit
Answers (1)
Aurum 2020-09-15 03:55:54
0
Recommendations
Comments (0)

Top reviewers you may like:

Aurum 2020-07-27 15:46:31
0
Recommendations
Comments (0)

Top reviewers you may like:

Aurum 2020-07-27 15:46:31
0
Recommendations
Comments (0)

Top reviewers you may like:

Q: Where can I find english data sheet?

Asked by giuliano on 2020-07-24 02:39:17

Aurum Not sure it exists nor you really need one unless you wanna write a driver for the controller chip. Just make a search on google for "arduino ILI9341" or the chip your display uses and you'll find sufficient information.

2020-07-24 03:36:06 Helpful (1)
Submit
Answers (2)

Q: I have the 2.4" unit 240x320. Should the VCC be 5v or 3.3v?

Asked by BG573543554 on 2020-07-07 11:19:09

Aurum The ILI9341 chip was designed for 1.65V ~ 3.3V operation. There is a regulator chip onboard for power, I'm not sure about the data lines though, so safest is to drive it by 3.3V.

2020-07-08 04:15:26 Helpful (1)
Submit
Answers (2)

Q: to Austria via Air Parcel and now is in ALASHANKOU? :))

Asked by Daniel on 2020-06-30 01:52:36

Aurum Why, the direction is perfect.. At some point it might get on a flight :)

2020-06-30 02:47:56 Helpful (0)
Submit
Answers (1)
Aurum 2020-06-09 16:05:27
0
Recommendations
Comments (0)

Top reviewers you may like: