All Messages

BG571738181 You don't need 3 pins for a standard limit switch. This if for the ender which only uses two pins like most should. I would only imagine you might need a 3rd pin if you were using optical switches

2020-07-07 09:52:14 Helpful (0)
Submit
Answers (4)

BG571738181 You SHOULD zero it ever time! It takes 2 seconds and ensures that you will get an accurate measurement.

2020-06-21 09:06:55 Helpful (0)
Submit
Answers (2)

BG571738181 My limited knowledge of this would suggest that it should work, because the cap is only going to output 12v and it is only going to draw the current it requires I would expect it to do the job fine... But you should just get a lipo and call it a day much safer.

2020-06-02 03:17:15 Helpful (0)
Submit
Answers (1)

Q: is there a limit on the sd card capacity? Would 1TB be too much?

Asked by muffins77 on 2020-04-16 04:13:59

BG571738181 Good luck trying to fill it.. just use what it comes with and if you care that much use a print server instead Don't be an Id!ot.

2020-04-16 05:51:43 Helpful (0)
Submit
Answers (6)

BG571738181 - heat with lighter to melt - roll left and right to avoid burning what ever it may contain - as it evaporates slowly inhale - when cooling roll to allow the contents to crystallize as a thin layer and to require less heat to melt once again. - realize you are ruining your life smash the pipe and dispose of it - get better and save money.

2020-02-14 03:49:03 Helpful (0)
Submit
Answers (9)

BG571738181 Sure you can order it, but usage would depend if crystal meth is legal in Saudi Arabia.

2020-02-14 03:39:05 Helpful (0)
Submit
Answers (4)
brendan 2020-01-15 01:26:38
0
Recommendations
Comments (0)

Top reviewers you may like:

BG571738181 2018-03-12 08:14:11
0
Recommendations
Comments (0)

Top reviewers you may like:

BG571738181 2018-03-12 08:12:43
0
Recommendations
Comments (0)

Top reviewers you may like:

BG571738181 2018-03-12 08:12:10
0
Recommendations
Comments (0)

Top reviewers you may like:

BG571738181 2018-03-10 19:06:10
0
Recommendations
Comments (1)

Top reviewers you may like:

BG571738181 2018-03-08 06:12:37
0
Recommendations
Comments (0)

Top reviewers you may like:

BG571738181 2018-03-08 06:10:20
0
Recommendations
Comments (0)

Top reviewers you may like:

BG571738181 2018-03-08 06:09:16
0
Recommendations
Comments (0)

Top reviewers you may like: