All Messages

Q: does it come with screws for installation?

Asked by BG365421121 on 2020-11-13 07:40:33

Mark it comes with 2 screws and 2 red rawl plugs, but i found the rawl plugs to be shorter than the screws and not of good quality so i used better quality rawl plugs for use when i drilled into my bricks, dont drill into the morter and ensure your are a cm down from the morter line if fitting to brick wall .since buying theer is a 200 anbd something led light out now, which is fractionally dearer so you might be better getting these instead.https://www.banggood.com/1-or-2-or-4X-208-LED-Solar-Power-PIR-Motion-Sensor-Wall-Light-Outdoor-Garden-Lamp-Waterproof-p-1555892.html?rmmds=mywishlist

2020-11-13 08:47:25 Helpful (0)
Submit
Answers (4)

ShadeyB Come’s with 0.4mm nozzle which are standard for printer. Pack of 25 replacement nozzles can be bought for £6 or less

2020-11-13 08:22:41 Helpful (1)
Submit
Answers (1)

ShadeyB This works fine without any upgrades, I would suggest upgrading the bed levelling springs, this reduces the amount of times you need to level the print bed

2020-11-13 08:20:35 Helpful (0)
Submit
Answers (2)

Q: does it fits with an AV5G port of a ROTG01 receiver ?

Asked by Maxence Dreuillet on 2018-01-16 09:28:28

Mark Ihave no idea i bought them for another RC use, to connect to flight controllers on my quads that im building

2020-11-13 04:45:10 Helpful (0)
Submit
Answers (2)

Q: connect 5 mm shaft?

Asked by BG192455524 on 2020-06-21 08:01:10

Mark areyou asking will it fit onto a 5mm shaft?

2020-11-13 04:43:41 Helpful (0)
Submit
Answers (2)

Mark thebutton next to the sensor has 3 modes , one stay on dim light mode 2 - stay on bright light, mode 3 which is the pir mode only comes on very bright when detecting movement, if you only have one mode then unit might be faulty, try covering up the solar panel if testing in daylight then the light thinks its nightime, then test, happy to help further, also see my review too.

2020-11-13 04:42:19 Helpful (0)
Submit
Answers (2)

chazzyo I don't know about replacing the filter. You breathe in through the filter and out through a shielded exhaust valve which dumps your unfiltered breath downward. I smelled strong factory plastic when the mask arrived and I put it on. I soaked it in warm dish soap for an hour and it doesn't smell any more.

2020-11-11 10:32:07 Helpful (0)
Submit
Answers (1)