All Messages

Paul I am using one on my fms cub . It helps at take off and prevents groundlooping. Connect your Servo is to the out positions on the giro in my case the rudder. Then connect the leads which came with the giro from the in positions to your receiver that is rudder to rudder, ailerons to aileron, elevator to elevator . Use one free out position to connect to to your servo. In my case there was a second open aileron which I connected to channel 7 on my receiver which was a on and off switch on my radio. With this I can switch the giro on or off. The giro must lie parallel with the fuzz of the plane and nearby your receiver. Paul

2022-04-12 03:10:03 Helpful (1)
Submit
Answers (2)

Paul Could be a loose or dirty magnet. Also check the wires connecting on the motor from the Esc . I also had a problem that one of the motor wires did not connected correclly to the motor had to solder it back.

2022-02-13 04:18:57 Helpful (0)
Submit
Answers (2)

matt66 yes they are the same as b5w 4k these are widely available

2021-11-05 02:21:17 Helpful (0)
Submit
Answers (1)

Paul Hendrik ek neem aan Jy is van Suid Afrika? Ek het ook een vd epik Drone’s bestel maar ongelukkig Met net een battery . Banggood se hulle kan nie nog een pos na Suid Afrika nie. Weet jy waar n mens nog so n battery kan kry? Paul

Hendrik Vermeulen 16/12/2018
4
Comments (2)

simole88 Yes,FMS 1400mm J3 Club V4 is supported by FMS Reflex Param V2.0 You can load the model and control it from the gyro safely! I hope I was helpful

2021-09-26 09:47:24 Helpful (0)
Submit
Answers (1)

Q: Can I change the lens to a zoom lens?

Asked by BG393183601 on 2021-04-13 02:39:38

Paul No it has a fixed lens

2021-04-13 11:40:18 Helpful (0)
Submit
Answers (2)