All Messages

LukasekP 2019-07-01 13:00:43
1
Recommendations
Comments (0)

Top reviewers you may like:

LukasekP It doesn't. Such a printers have a switch or proximity sensor near the tip of the print head that “probes” specific points on the platform when the bed levelling process is first initiated. This model has none one.

2020-08-25 07:51:41 Helpful (2)
Submit
Answers (3)
LukasekP 2020-08-06 15:02:34
0
Recommendations
Comments (0)

Top reviewers you may like:

LukasekP 2019-07-10 12:45:26
2
Recommendations
Comments (0)

Top reviewers you may like:

LukasekP 2019-07-01 13:00:43
0
Recommendations
Comments (0)

Top reviewers you may like:

LukasekP 2019-07-01 13:08:25
0
Recommendations
Comments (0)

Top reviewers you may like:

LukasekP 2019-07-01 13:08:26
0
Recommendations
Comments (0)

Top reviewers you may like:

LukasekP 2019-07-01 13:24:09
0
Recommendations
Comments (0)

Top reviewers you may like:

LukasekP About twenty amperes I guess. Higher current impulses could destroy the balancing circuit.

2019-10-04 08:09:12 Helpful (0)
Submit
Answers (2)

LukasekP This unit consumes 12V x 15A x 2 H = 360 Watts per two hours, but it must be powered by stabilized source, which would consume even more. So let say that answer would be somewhere bellow 500 Watts i.e. 0.5 kWatt per day.

2019-09-06 06:36:03 Helpful (1)
Submit
Answers (3)

Q: How many Volts are required to power the Piezoelectic?

Asked by jdelapazus on 2019-06-05 10:12:05

LukasekP Given the power load 35 W and impedance bellow 20 Ohm the voltage should be bellow 25 Volts

2019-08-02 02:17:09 Helpful (0)
Submit
Answers (1)