Customer Reviews

4.93 out of 5
See all 91 reviews
Write a Review
  • All Reviews (91)
  • Image (5)
  • Video (0)
  • All Star
    • All Star(91)
    • 5 Star(85)
    • 4 Star(6)
    • 3 Star(0)
    • 2 Star(0)
    • 1 Star(0)
Sort by:
Top Review
  • Top Review
  • Most Helpful
  • Most Recent
Reviews only from your country (Viet Nam)
|
Show Original

A part of the review has been auto-translated.

  • 05/09/2017

    Buyer should be aware that there are at least 3 versions of this alarm sold by Bangood under the same name. If they all work as well as mine they will be very valuable to the RC Modeller. My name is Phil Elliott and I have written a user guide with an illustration so that non-Chinese modellers can understand the one that I received - let's call it v3. Chinese modellers can get the guide from Bangood I believe. The instructions are shown in the attached jpg picture. I installed mine in a flying wing and attached ch2 through the pcb and ch6 into the other end. See the attached picture. The beeper is efficient with a low tpd in the 10's of mW region. Beeper is ordinary to good loudness level and the LED is pretty bright too. See the pictured too. All the best from down in Tassie. Phil Elliott

    Comments (2)
    Show Original
  • 01/09/2016

    With a low price, you can simply find your loved plane in case of crash. At the moment there's not user manual, but I published an image to explain how to plug it.

    Comments
    Show Original
  • 10/05/2019

    It is very good module for RC. This finder module have alarm ON/OFF control terminal as C.(see photo) A is the signal line from reciver. B is output line to savo

    Comments
    Show Original
  • 27/02/2021

    Great product, works very well and super functional.

    Comments
    Show Original
  • 29/07/2017

    Tiene buena calidad, el led es muy brillante y es útil en caso de que pierdas tu modelo

    Comments
    Show Original
  • 09/01/2022

    the system is very useful it connects in series with one of your commands. after one minute of inactivity the chosen command starts to sound it stops the moment you operate the servo. the buzzer is not very loud at the distance of 50 m it feels quite.

    Comments
    Show Original
  • 16/10/2021

    Tested working.

    Comments
    Show Original
  • 28/07/2021

    in my plane but I hope I never need it

    Comments
    Show Original
  • 30/06/2021

    will test soon

    Comments
    Show Original
  • 29/11/2020

    setting this thing up might be pretty confusing. Since there seem to be different versions on the market and it´s almost impossible to find the right instructions, i suggest following procedure: First try to put it with the servocable and one additional cable between the receiver and the servo. After you found the right pairing, the third connector goes to your channel which you then assign on your TX. Other than that, it works fine.

    Comments
    Show Original
Show:

    Total 0 pages

    Go to page

    Go
    recommendation for you
    • US$19.99
    • US$35.59
    • US$40.99
    • US$9.90
    • US$31.99
    • US$16.50
    • US$6.85
    • US$8.59
    • US$7.99
    • US$19.99
    • US$25.99
    • US$7.80
    • US$36.99
    • US$17.99
    • US$27.99
    • US$89.99
    • US$45.99
    • US$13.99