I purchased this to make a tool post drill for my lathe. I just wanted to use the drill as is but for what I wanted to do with it the chuck had no rigidity because it is only supported by the 2.5 MM motor shaft. So I improvised with some 450 helicopter parts. Its rigid and now has lots of torque. The block is 3D printed, I was going to make it out of Aluminum but for right now I think It is fine as is.

I purchased this to make a tool post drill for my lathe. I just wanted to use the drill as is but for what I wanted to do with it the chuck had no rigidity because it is only supported by the 2.5 MM motor shaft. So I improvised with some 450 helicopter parts. Its rigid and now has lots of torque. The block is 3D printed, I was going to make it out of Aluminum but for right now I think It is fine as is.

I purchased this to make a tool post drill for my lathe. I just wanted to use the drill as is but for what I wanted to do with it the chuck had no rigidity because it is only supported by the 2.5 MM motor shaft. So I improvised with some 450 helicopter parts. Its rigid and now has lots of torque. The block is 3D printed, I was going to make it out of Aluminum but for right now I think It is fine as is.

very good

very good

very good

speed good

speed good

speed good

Okay

Ok

Okay

Per lavori molto piccoli è ottima, non si può pretendere di più su impegni maggiori, il proprio lavoro lo fa perfettamente.

Per lavori molto piccoli è ottima, non si può pretendere di più su impegni maggiori, il proprio lavoro lo fa perfettamente.

Per lavori molto piccoli è ottima, non si può pretendere di più su impegni maggiori, il proprio lavoro lo fa perfettamente.

ok

ok

ok

llego rápido y en buenas condiciones

llego rápido y en buenas condiciones

llego rápido y en buenas condiciones

Vsjo ok.

Vsjo ok.

Vsjo ok.

Good product, you can use it as a hand drill with variable speed, or attached it to a mini lathe, or use as dremel. Imput 100 -240 V AC allow you to use it in any country.

Good product, you can use it as a hand drill with variable speed, or attached it to a mini lathe, or use as dremel. Imput 100 -240 V AC allow you to use it in any country.

Good product, you can use it as a hand drill with variable speed, or attached it to a mini lathe, or use as dremel. Imput 100 -240 V AC allow you to use it in any country.

the products was very well packaged and it was in good condition

the products was very well packaged and it was in good condition

the products was very well packaged and it was in good condition