IAmBastian
- My Contents
- All Messages
- Reviews
- Comments
- Answers
- Questions
Answers
Q: Is the stack compatible with the DJI Digital System?
Asked by BG434810425 on 2021-08-05 04:43:19
Q: What is the diameter of the screw head?
Asked by vipulan on 2018-11-23 20:19:31
IAmBastian 8mm
Helpful (0)
Q: How do I get the bits from the case? They all seem to be locked in their holders and won’t come off?
Asked by OzBlueDragon on 2018-12-12 20:55:02
IAmBastian move them to the bottom position of the clip. There's a small opening where you can slide it through to get it out with a small wiggle
Helpful (1)
Q: Will this be the repair of mobile
Asked by Sonusjjaiswal28 on 2019-03-02 21:45:22
IAmBastian The bits will work on pretty much all phones
Helpful (0)
IAmBastian You need to screw the clip on pretty tightly. It will then bend the inner clips to stop the bit from moving inside
Helpful (0)
IAmBastian Push the bits to the bottom of the holder and then you can (with a bit of wiggling around) get them out
Helpful (0)
IAmBastian Theseare basic, PWM, ESCs. They are not really programmable in any way cause they are meant to be used directly with a receiver. Creating a PWM sinal with an Arduino is really easy, however, so controlling this ESC with an Arduino/ESP is easy.
Helpful (2)
IAmBastian Yes, it works fine with the Digital FPV system. You just need to know how to wire it and set it up in betaflight (DJI Preset works flawlessly)
Helpful (0)