All Messages

Maminbot 2018-02-21 04:04:46
1
Recommendations
Comments (0)

Top reviewers you may like:

Maminbot 2018-02-22 01:02:18
4
Recommendations
Comments (1)

Top reviewers you may like:

Maminbot 2018-03-08 11:11:21
1
Recommendations
Comments (0)

Top reviewers you may like:

Maminbot 2018-03-25 23:16:05
2
Recommendations
Comments (0)

Top reviewers you may like:

Maminbot 2018-02-05 17:38:21
1
Recommendations
Comments (0)

Top reviewers you may like:

Maminbot 2018-02-01 02:54:10
0
Recommendations
Comments (0)

Top reviewers you may like:

Maminbot 2018-01-22 03:19:33
0
Recommendations
Comments (0)

Top reviewers you may like:

Q: what is the diameter of the hole required for this device?

Asked by Coetz on 2017-12-16 08:18:04

Maminbot 46 mm or 1.8 inch exactly. So you will need a slightly larger bore with some gap as leeway. However bear in mind that the barrel does not come with a tensioning mechanism so you may need to pack it with some foam, otherwise it may rattle about. The surface cap diameter overhang is 67.8 mm or 2.67 inch.

2018-01-17 07:34:52 Helpful (1)
Submit
Answers (1)

Q: Where is the power supply?

Asked by Glauve on 2017-12-26 12:14:40

Maminbot The 3 USB sockets are directly attached to a circuit board with a switch mode power supply. It's all contained in the tube below the surface.

2018-01-17 07:21:14 Helpful (0)
Submit
Answers (1)
Maminbot 2018-01-17 05:19:15
0
Recommendations
Comments (0)

Top reviewers you may like:

Maminbot 2018-01-17 05:17:13
0
Recommendations
Comments (0)

Top reviewers you may like: