TimothyBarnum
TimothyBarnum I haven’t received it yet so I don’t know
2021-11-25 09:56:43 Helpful (0)Q: What is the battery AH that it comes with?
Asked by M6GPS on 2021-08-28 12:28:04
TimothyBarnum Sorry, nothing on battery or in directions says the AH. It's Li-on and measures 4 and one half in long by 3 in wide by 1in thick and weighs 10 ounces if that is any help.
2021-08-28 12:42:34 Helpful (1)
TimothyBarnum Absolutely. I am using one of the DANU tips on my JCD 8898 and it’s great. Heats up very quickly
2021-01-28 02:03:58 Helpful (0)Q: Can I convert it to glow and if yes is the OS 0.15LA enough?
Asked by BG955475449 on 2021-01-28 05:35:07
TimothyBarnum I had a 1-2 A 049 engine on a control line plane in 1951. It was a little smaller than this plane but just as heavy. I hadn’t flow a plane until a couple of years ago. The electric engines of today are simple to start, don’t require highly flammable fuel or a big battery for start up. It had only one speed. I still have the engine, a Holland Wasp .049 but I can’t see any.
2021-01-28 01:59:52 Helpful (1)Q: what size are the connection ports for the servos and motor? jst 1.0?
Asked by Jjj444 on 2021-01-06 11:25:41
TimothyBarnum Jst 1.0 means the pin spacing between the three pins in the female connector on the board are 1.0 mm apart. Texas 2017 is correct that 1.7g servos required have a pin spacing of 1.25 mm. So they are incompatible. I did find male jst 1.0 male 3 pin connectors with leads on Amazon a year ago. I plan to cut off the jst 1.25 connector from the servos and solder on the Amazon connectors. Note also that the servos need to be low voltage since a 1S 3.7 volt battery is the max for this receiver.
2021-01-07 02:01:45 Helpful (1)
Q: is this need any flight controler
Asked by Raj Raj on 2020-11-09 07:57:49
TimothyBarnum I haven't used this yet, but I purchased it for micro RC 450mm wingspan airplane it which includes a brushed motor. The receiver is meant to be compatible with a dsm2 dsmx receiver. The Esc is integrated as it doesn't need to provide a step down voltage to lower power servo's. It used a 3.7v battery. Larger planes tend to used Brushless motor and 7.4 or greater batteries so need a separate ESC. The Spectrum DSM2 transmitters are a lot more expensive than the AFSHD2 FlySky transmitter but FlySky doesn't seem to make a compatible receiver. There is a problem with the jr 3 conductor connector for the servo. On this receiver, the spacing between pins is 1mm, but the 2.7 low power servos (for 3.7v) have 1.25 pin spacing. I found some connectors on Amazon which are 1mm spacing and planned to replace the servo connector cutting it off and soldering on the 1mm one.
2020-11-09 03:56:52 Helpful (0)
Q: can you program flaperons with 2 ailerons channels?
Asked by DICKFRANKLINhsv on 2020-09-07 12:07:58
TimothyBarnum I'm sorry, I haven't needed to do this so I don't know. I assume you have downloaded the manual from FrySky. Have you checked Youtube?
2020-09-07 04:30:47 Helpful (0)
TimothyBarnum I downloaded the manual on line probably from frysky. I have not tried to do trainer or student mode. They are not listed in the table of contents but as you have probably noticed , there is a trainer port on the back labeled as such in the manual. Sorry I can’t be more help.
2020-08-28 09:56:35 Helpful (0)
TimothyBarnum Can this be used with an airplane?
2020-07-02 11:42:45 Helpful (0)We sincerely invite you to subscribe to the Invite Answer email!
If you subscribe, we will invite you via email to answer questions people have about products. By subscribing you]ll also earn the "Helpful Badge"! You can unsubscribe at any time on the privacy settings page.
Help others and be happier!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
Jaquen what is PWM?
2019-03-23 02:20:33 Helpful (1)