All Messages

John If you are considering these, make sure they will fit your lathe. Because my lathe was in pieces, I did not measure the height of the cutting point. Now the lathe is almost reassembled, I have found that the cutting point is about two millimetres too high with the Quick-change tool holder in its lowest position. I will be able to modify the tool holder to make it work, but I should have purchased a 10mm set instead of the 12mm.(Still haven't used them tho').

John 30/04/2021
0
Comments (1)

John UPDATE: I don't have vast experience of different filaments, but I have been pleased with the way these have performed.

John Colvin 19/06/2018
0
Comments (1)