Active RF Isolation Distributor Suitable for RF Signal Radio Antenna SDR GPSDO Signal Source
A part of the review has been auto-translated.
Low noise RF signal distributor. Operation is good until 150 or even 200 MHz but noticeable attenuation occurs when passing this limit. Anyhow, until 150 MHz is perfect. It came in an round case along with the USB-C power cable
Smaller than expected case. I tried inserting it in front of the receiver I have been using so far. It seems to have an effect.
I bought it to consolidate the antenna terminals of the SDR. Tested the characteristics from 100kHz to 200MHz with a spectrum analyzer. There is a dip point in the frequency characteristic, but it seems to be no problem for the part used for distributing the received antenna signal.
arrived undamaged and was well packed. Within the time frame even in this festive. I will test later.
Works as advertised but read the description. The end plate is marked 100kHz-300MHz, description says top range is 150MHz. It does go to 150 with a roll off starting at 100MHZ dropping 23db @ 300MHZ. Up to 150MHz the thru loss is <1db. It does meet the specs in the description and works quite well for the intended purpose.
Works very well. It has almost no increase in noise. Only 1 to 2 dB. Recommended. Good dealer A
Super! I use 3 or 4 SDR receivers and this is a good solution.
Fast delivery. Works great!
Product as described. Very good quality. 0.8 dbm split loss is not noticeable. I would by another one when they bring new version which supports from 1 khz to 450 mhz. Current version supports up to 300 mhz. A six way splitter is more required as I need more...please bring 6 way with 1 khz to 450 mhz Version...
Works good, GAIN is ØdB input to ØdB on every output_ _Gain is Flat upto 100Mhz__-3dB at 106Mhz_-8dB at 150Mhz_-25dB at 300Mhz.